Oven Fried Chicken Recipe (Super Crispy & So Easy!) - Cooking Classy (2024)

FAQs

What is the trick to getting crispy chicken? ›

Fry it twice.

Try Fontana's method for “blanching” fried chicken: Heat oil to 250 degrees and cook chicken breasts for about five minutes, or bone-in chicken for about 12 minutes. Let them rest for 15 to 20 minutes, then fry again, two to three minutes for breasts or five minutes for bone-in.

That trick is a sprinkling of baking powder, and it'll get you the crispiest, crackliest bites of fatty, salty skin imaginable, whether you're cooking just one thigh, a plate of wings, or an entire bird. Baking powder, it turns out, is good for quite a lot more than baking.

Chicken skin needs to be dry in order for it to crisp when cooked. Whether or not you rinse the chicken before prepping, you need to make sure the skin is as dry as possible. After removing the chicken from the package (and washing it, if that is your preferred method) pat each piece dry with paper towels.

Although paper towels are commonly used to absorb the excess oil, placing the hot, cooked chicken on a paper towel will cause the crust to steam and turn soggy. Instead, let the chicken rest on a wire cooling rack set over a paper towel or baking sheet to collect the grease.

Bake in a high-temperature oven for around 5-8 minutes or until the coating is crispy once more. If you wish for the meat to remain crisp for a few hours following the cooking, lower the temperature to 200 degrees F (100 degrees C) and keep the chicken to rest until prepared to cook it.

In order to get crispy wings without frying, you need to dry out the skin. That's where a coating of baking powder and salt comes in. The baking powder and salt help break down the proteins in the skin, draw moisture to the surface, and also aid in browning.

My not-so-secret tip to the best fried chicken is a combination of FLOUR, CORNSTARCH, and BAKING POWDER. When mixed with the flour, the cornstarch makes the flour coating crispier and gives it that golden brown color! (It has to do with prevention of gluten development.)

The baking powder raises the pH of the surface, allowing it to crisp better*), and tossing in plain cornstarch to absorb some surface moisture and create a rougher texture for the batter to adhere to. *See more on the science of baking powder and chicken wings in this article on oven-fried buffalo wings.

Substitute each teaspoon (5 grams) of baking powder in the recipe with 1/4 teaspoon (1 gram) baking soda and 1/2 teaspoon (2.5 grams) vinegar. Summary: Each teaspoon (5 grams) of baking powder can be replaced with a 1/4 teaspoon (1 gram) baking soda and a 1/2 teaspoon vinegar.

How do you keep chicken crispy in the oven? ›

Baking with a wire rack: Achieve optimal crispiness by baking your food on a wire rack. Unlike traditional baking directly on a tray, where the bottom might become soggy due to trapped moisture, the wire rack facilitates 360-degree air circulation around the entire food item, allowing any excess moisture to escape.

If you crank your oven to at least 450°F and position a rack in the top third (the hottest part) of your oven and slide some chicken in there skin-side-up, the skin will be crisp by the time the chicken is cooked through. To help it out, baste it a couple times while it roasts with pan-drippings, butter, or oil.

Always dip your chicken in beaten egg before coating

Dipping your chicken in egg helps the breadcrumbs, or whatever coating you use, adhere evenly to the outside of the cutlet. You should start with a thin layer of flour, which gives the egg a better surface to cling to, then the egg, then the coating.

The most common reasons breading doesn't stick is that: You didn't properly dry the meat. You didn't put a starch coating on the meat before dredging. Your oil wasn't properly heated.

The chicken is then air-dried for 10 to 12 hours before being flash-fried, then oil-poached. The skin gets its signature crispiness from 10 to 12 minutes of basting with scalding hot oil right before serving.

The secret to succulent fried chicken starts with a marinade or brine, which keeps the chicken at its peak juiciness. Fried chicken traditionalists generally choose a buttermilk marinade while others swear by a brine, which is a mixture of sugar, salt and sometimes spices dissolved into water.

If your oven temperature is too low, the chicken may steam instead of crisping up. Make sure to preheat your oven to the recommended temperature (usually around 400°F to 425°F) and bake the chicken on a high rack to allow air circulation around the chicken.